Hi there,

I picked up a Skystar2 Air2Pc card.  I've tried to scan for channels with it (Rogers Cable in Canada) with no success using the dvbapps atscscan tool.

I seem to just get alot of timeouts.  I'm not sure how to get a scan of available channels from this card.  I've tried using a list of freq I found somewhere online:
A 525000000 QAM256
A 579000000 QAM256
A 597000000 QAM256
A 657000000 QAM256
A 681000000 QAM256
A 699000000 QAM256
A 771000000 QAM256
A 837000000 QAM256
A 843000000 QAM256

I'm not certain these are even correct.  I don't get anything with them either.  I've tried each of the standard files with the same results.  I found a one line example from a channels file, and it looks like azap locks to the channel so I *think* its working.

My dmesg output is:
b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully
flexcop-pci: will use the HW PID filter.
flexcop-pci: card revision 2
DVB: registering new adapter (FlexCop Digital TV device).
b2c2-flexcop: MAC address = 00:d0:d7:30:1a:8c
b2c2-flexcop: i2c master_xfer failed
b2c2-flexcop: i2c master_xfer failed
b2c2-flexcop: i2c master_xfer failed
nxt200x: nxt200x_readbytes: i2c read error (addr 0x0a, err == -121)
Unknown/Unsupported NXT chip: 00 00 00 00 00
b2c2-flexcop: i2c master_xfer failed
lgdt330x: i2c_read_demod_bytes: addr 0x59 select 0x02 error (ret == -121)
bcm3510: Revision: 0x1, Layer: 0xb.
b2c2-flexcop: found the bcm3510 at i2c address: 0x0f
DVB: registering frontend 0 (Broadcom BCM3510 VSB/QAM frontend)...
b2c2-flexcop: initialization of 'Air2PC/AirStar 2 ATSC 1st generation' at the 'PCI' bus controlled by a 'FlexCopIIb' complete

I'm not certain if this is correct -- are there module options I should be using to make sure I get the correct frontend?

An example or a channels.conf file would be appreciated too but any advice please.

Thanks
Norm