[vdr] Re: switch recording to secondary interface no longer works

["Robert Schneider" <Robert.Schneider@de.ibm.com>]

there was a bug in pre3. Either upgrade to pre4 or increase your 
PrimayLimit in the configuration to something higher than 0.

I would assume that would cure the problem

vdr-bounce@linuxtv.org wrote on 16.03.2002 19:58:45:

> Hi All,
> 
> after switching from version 0.99 to 1.0.0pre3, vdr always starts the
> recording on the primary IF although I have two cards installed. Even
> switching the recording to the secondary interface does not work (still
> remains on the primary). When switching back to 0.99 everything works 
fine
> again. Do I need to adapt something or is this a bug?
> 
> Regards
> Steffen
> 
> 
>