At 06:24 11/07/2003, you wrote:
On Friday 11 July 2003 01:21, Gregor Lawatscheck wrote: > At 22:20 10/07/2003, you wrote: > > > Either your revision of the card makes a difference or you're in > > > the lucky position that somehow vdr or the driver just never > > > touches the tuning part of the dvb-s. Add a printk to SetPIDs() (av7110.c) and verify that the pids are set to zero when there is no signal. av7110_before_after_tune() calls SetPIDs(0,0,0,0,0) if the frontend looses signal. AFAIK this code was added to avoid arm crashes...
OK, thanks I'll check that once I have the box up running again.
It takes around 4-6 hours. Before that the load goes to around 40-50% if tuned to a sat channel without having signal. It only recovers on reloading the drivers. The tuner of my 1.3 says BSRV2-301A.> > > What revision is you full dvb-s card? I've got a 1.3 here. Which > > > version of vdr are you using? How's your EPG setup for vdr - > > > standard or altered so it doesn't scan at night? > > > >I think the DVB-s is a 2.1 - no J2 connector > > Most interesting. I'm getting a 1.6 from ebay with broken tuner soon. > Let's see whether there's any difference there. It it even feasible > to assume it could be the revision of the card that makes a > difference here? The 1.3. has a different frontend chip. I tested my Rev. 2.1 Nexus (stv0299-based) without sat signal: It did not crash within several hours. How long does it take in your setup until the arm crashes?